I think I am fucked
 

my timing belt tensioner bolt broke off in the block while trying to remove it. it is so tight it wont come out it seems the owner of the engine before me put locktite on it. I think the only way is to pull the motor and drill the hole out and put a sleave in or coil to replace the thread I am so pissed.

Re: I think I am fucked
 

You should have heated it up. Helicoil it, shouldn't be that bad.

Re: I think I am fucked
 

after I broke it, welded a bolt to it 6 times, >:( and it just keep on breaking off more into the head

Re: I think I am fucked
 

Damn. Did you try an easy-out?

Re: I think I am fucked
 

Should have said MAPP gas and an easy out.

Re: I think I am fucked
 

I dont know what mapp gas is, and I dont have an easy out, its a holiday in Germany this wekend so I have to wait till next week :(

Re: I think I am fucked
 

Mapp gas works in a regular propane torch, but it's a LOT hotter. An easy out is basically like a reverse drill bit (best way I can describe it). You drill a hole in the end of the bolt, as perpendicular to the bottom of the bolt as possible. You want it go to down the exact center of the bolt. Then you basically use a ---- load of heat, and start turning the easy out counter-clockwise, so it will tighten. As it tightens in, it "should" extract the bolt. As I said, head the ---- out of it, as red hot as you can, that should help.

Re: I think I am fucked
 

If you already welded to it that bolt will be harder than ---- to drill, and its a holiday all over the world ::)

Re: I think I am fucked
 

Get a hammer drill, get a tap, and a cobalt or someth'n drill bit and do it that way.

Re: I think I am fucked
 

What did you weld it with? if you were able to get a tig torch up there to weld it, you can easly get a 90 degree drill and drill it out and tap it.