screwdriver always works .

 

does the screwdriver not just rip right throgh both side and when you crank on it it rips the oil filter?

 

stab a large screw driver through it and turn it or worst comes to worst.. spray the contact point with something that will eat the rubber 0-ring so it spins off easily

 

1 1/2 ft channel locks............plenty of room with the airbox out of the way also

 

if u can not loosen up that bitch with a screwdriver( ) try to tighten it more with the screwdriver then it should came right off.

 

"Ghetto HMT Oil filter wrench" writeup: Supplies--- Get access to 1 leather belt. I'm talking the kind your mom used to threaten to get from your father's dresser when you were a little ----.
1 piece of 36 grit or 80 grit sandpaper. That cheap toilet paper you get for like 28 cents a roll will do just as well since I swear it's the same stuff :P

Assembling your new homemadeturbo oil filter Ghetto riggdiculous wrench---
Cut your sandpaper into strips about 2.5-3" wide and about 8-10" long depending on your oil filter size. Wrap that stuck *** oil filter in the sandpaper (grit side down dummy ) and tighten the belt around the oil filter as tight as you can. Now give it a tug in the "lefty loosy" position and watch that sum bitch spin free.

Enjoy. Compliments of Tranceminister.

Quality illustrations, diagrams, blueprints and pictures can be posted if needed.

 

man up -----...

 

Yeah, no ----. Want my 5 month old son to help you out?

 

not always. i totally ripped the oil filter apart. i think i may have over tightened it :P, my dad ended up taking it out for me using a flat screw driver and a hammer

 

use the scre driver as a last resort, becasue half the time it just cuts the filter into pieces. get oil filter pliers or a type of filter wrench that tightens as you turn it.