is this a good deal?? or could you show me somethin better??(piston/rods)
#21
Re: is this a good deal?? or could you show me somethin better??(piston/rods)
Originally Posted by 2stockrocketz
Originally Posted by rawr
Originally Posted by 2stockrocketz
Originally Posted by boosted_hatch_216
you could maybe use like a 10.5-1 from a d16a6 to drop the compression in a zc. but you may have to worry about the piston to valve clearance.
#22
Re: is this a good deal?? or could you show me somethin better??(piston/rods)
Originally Posted by rawr
Originally Posted by 2stockrocketz
Originally Posted by boosted_hatch_216
you could maybe use like a 10.5-1 from a d16a6 to drop the compression in a zc. but you may have to worry about the piston to valve clearance.
#23
Re: is this a good deal?? or could you show me somethin better??(piston/rods)
.10 over is .25mm, roughly. Not exactly, but any machine shop won't do exactly .10 anyway, they will do within manufacturers specs.
#24
Re: is this a good deal?? or could you show me somethin better??(piston/rods)
Originally Posted by TorganFM
.10 over is .25mm, roughly. Not exactly, but any machine shop won't do exactly .10 anyway, they will do within manufacturers specs.
#26
Re: is this a good deal?? or could you show me somethin better??(piston/rods)
Originally Posted by amh0001
I know jeff built a ZC, and after it all, said it was a waste of time.... not to kill your fire, but maybe just a note
#27
Re: is this a good deal?? or could you show me somethin better??(piston/rods)
ok in case i find out that this build wont be worth the time or money...... if i bought some piston's that are .10 over would i have to sleev the block?? (i might do a semi-build) and if i dont sleeve how safe/unsafe would that be
#28
Re: is this a good deal?? or could you show me somethin better??(piston/rods)
Originally Posted by 2stockrocketz
ok in case i find out that this build wont be worth the time or money...... if i bought some piston's that are .10 over would i have to sleev the block?? (i might do a semi-build) and if i dont sleeve how safe/unsafe would that be
#29
Re: is this a good deal?? or could you show me somethin better??(piston/rods)
Originally Posted by 2stockrocketz
Originally Posted by 2stockrocketz
ok in case i find out that this build wont be worth the time or money...... if i bought some piston's that are .10 over would i have to sleev the block?? (i might do a semi-build) and if i dont sleeve how safe/unsafe would that be
Thread
Thread Starter
Forum
Replies
Last Post
Anubis_4_99
General Discussion
17
05-04-2006 08:22 AM
2stockrocketz
General Discussion
12
11-01-2005 05:39 PM
Chacko
General Discussion
95
05-05-2004 01:08 AM