Fuck.. I think I just stripped a nut that holds the valve cover down
Perfect timing with battle of the imports tomorrow. I was replacing a bad valve cover gasket and those rubber grommet deals for the spark plug holes and when I put the VC back on, the nut on the driver's side closest to the firewall that holds the valve cover down screwed down, but then stopped tightening. I tried tightening or loosening it, and it wouldn't move down or up. I tried pulling it out, but it won't either so I don't think the stud is snapped. The valve cover sits pretty flush as it should, but I'm going to have to get this bitch off eventually, how would I do this? Is it going to leak if I leave it like this? (all the other nuts are tightened down properly)
Here's a pic of how it sits: http://students.washington.edu/aptan/vcnut.jpg |
Re: Fuck.. I think I just stripped a nut that holds the valve cover down
Shouldn't leak but I wouldn't trust it. I snapped the stud once.. found a civic hiding in the woods and stripped some parts off of it. The valve cover was good for a day, no leaks.. i didnt even have a bolt on the top ;)
|
Re: Fuck.. I think I just stripped a nut that holds the valve cover down
put silicon around it to seal it for now, and when you have th remove it even IF the stud snapped it can be replaced with a new one as long as nothing stays inside the thread in the head.
|
Re: Fuck.. I think I just stripped a nut that holds the valve cover down
|
Re: Fuck.. I think I just stripped a nut that holds the valve cover down
LOL
|
Re: Fuck.. I think I just stripped a nut that holds the valve cover down
...honda closes in like 1/2 an hour.. I think I'm just gonna have to put silicon all around that general area. |
Re: Fuck.. I think I just stripped a nut that holds the valve cover down
Yeah, I saw some of your Solid Works stuff. I wish I was patient enough to do that junk, stenseltizm on here uses that program I believe.. kids a genius :o
|
All times are GMT -5. The time now is 04:25 PM. |
© 2024 MH Sub I, LLC dba Internet Brands