Re:CRX Project Pictures First Stage
Man I just realized that our main hoop plates WAY exceed the 1/8" requirement.
We used some plates pre-made from some off-road rollcage stuff and they're 1/4" thick. |
Re:CRX Project Pictures First Stage
have fun making that fit...
|
Re:CRX Project Pictures First Stage
Originally Posted by accordepicenter
have fun making that fit...
|
Re:CRX Project Pictures First Stage
haha, take some pics when you're doner fook
|
Re:CRX Project Pictures First Stage
Lookin good but stop using electrical connectors. :P solder and heatshrink those connections. ;)
|
Re:CRX Project Pictures First Stage
whoa that cars worth some money not a single mile on it lmfao i need to do that to my car
|
Re:CRX Project Pictures First Stage
Originally Posted by FooK
Originally Posted by AbaZ
I dont, you could just buy the book.
http://www.nhra.com/images/rollbar.gif |
Re:CRX Project Pictures First Stage
Good luck kiddo! Still miss my rex all the time :-\
|
Re:CRX Project Pictures First Stage
Originally Posted by B16MIKE
Lookin good but stop using electrical connectors. :P solder and heatshrink those connections. ;)
it gets an LS swap next. |
Re:CRX Project Pictures First Stage
Stage 1 continues - The Cage Begins
This is the makings of the main hoop sitting outside the car http://www.boostednw.com/projects/88crx/cage/cage1.jpg These next two are the side rails being mocked up, we didn't get much done tonite after a full day at work. These will be split to allow the main hoop to pass through, somewhere near the bend by the door http://www.boostednw.com/projects/88crx/cage/cage2.jpg http://www.boostednw.com/projects/88crx/cage/cage3.jpg This shows the slight bend and the foot of the sidebars, we opted to do this so it would be easier to center on a plate, yet we could get the upper portion of the bar as close to the door as possible. http://www.boostednw.com/projects/88crx/cage/cage4.jpg Shot of both sidebars just sitting mocked in place, you can see the main hoops oversized base plate, the main hoop leans back to meet the bend above it, then heads straight up to match the doorline http://www.boostednw.com/projects/88crx/cage/cage7.jpg Rear view of one side bar. http://www.boostednw.com/projects/88crx/cage/cage9.jpg Rear view both sides in place http://www.boostednw.com/projects/88crx/cage/cage10.jpg Next session at the shop we should get the bars coped out and start welding some stuff together. I'll post more as soon as I have some. |
All times are GMT -5. The time now is 08:00 PM. |
© 2024 MH Sub I, LLC dba Internet Brands