Re: clutch ?
 

I think this one will do just a bit better, http://store.lsdmotorsports.com/merc...a&Car=AC,HO,SS

* 105% Clamp Increase, 415 ft/lb Torque Capacity
* Included: Pressure Plate, 6-Puck Sprung Disk, Throwout Bearing, Pilot Bearing, and Alignment Tool
* Fits 90-91 Acura Integra

Re: clutch ?
 

that would be for a cable transmission, I have hydrolic.
when I say I am confused I mean man I don't what to do about this clutch situation.
I came up with a decision, I am going to install my old clutchmasters fx500 pressure plate with Gripforce disc used but in good shape, untill I sell enough ---- ti raise $1200 and buy a competition trin disc fron the cron.

Re: clutch ?
 

i rock that daily

Re: clutch ?
 

Have any of those that you fried been a 3 puck?

Re: clutch ?
 

Lol I ment this one, http://store.lsdmotorsports.com/merc...a&Car=AC,HO,SS

* 105% Clamp Increase, 415 ft/lb Torque Capacity
* Included: Pressure Plate, 6-Puck Sprung Disk, Throwout Bearing, Pilot Bearing, and Alignment Tool
* Fits 94-01 Acura Integra / 93-97 Honda Del Sol DOHC / 99-00 Honda Civic Si DOHC / 98-01 Honda Crv DOHC

Re: clutch ?
 

Hey man, you might wanna try a SPEC stage 3+...I've heard good things about them...

Re: clutch ?
 

for now my eyes are set on a competition twin disc, I have to sell some things buy it, so I will run my used CM FX500 until I can buy it

Re: clutch ?
 

ordered the competition twin disc, (xeno) hope this one will hold up, and last. been stressing the past 2 days trying to make a final decision. ---- is the most expensive single part in my setup. (bare block was around the same including S/H)

Re: clutch ?
 

24.5" slicks on 13" lenzo

Re: clutch ?
 

1,149$!!! It's more than the value of my car. Well my car worth nothing, not hard to beat... Let me know about that clutch I may want to buy one ;)