HomemadeTurbo - DIY Turbo Forum
Page 3 of 3
1
2
3
Show 40 post(s) from this thread on one page

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)
-   General Discussion (https://www.homemadeturbo.com/general-discussion-6/)
-   -   Car wont start, after installing turbo kit? (Integra GSR) (https://www.homemadeturbo.com/general-discussion-6/car-wont-start-after-installing-turbo-kit-integra-gsr-69269/)

d0nfry 10-31-2006 08:44 AM
Re: Car wont start, after installing turbo kit? (Integra GSR)
 
Originally Posted by jvelez2310

I do have gas (about a quarter tank), the car is not turning over.. it doesnt sound like it is trying to start, when I turn the key, the car makes no sound, and when I turn the key back to remove it from the ignition, it makes the little chirp sound. any ideas, suggestions??? I did not mess with my distributor or spark plug wires
Do you have an fmu? un hook it and hook up the lines how they were stock and try again.

kslice88 11-02-2006 12:26 AM
Re: Car wont start, after installing turbo kit? (Integra GSR)
 
ur car needs at least 9 volts from the battery to start. like stated above try and push start it.

ifly87 11-02-2006 11:20 AM
Re: Car wont start, after installing turbo kit? (Integra GSR)
 
Yeah wow, dont ecpect to drive it without some form of fuel management as soon at you see boost the ecu will go into limp mode and fall on its face. You can chip it yourself for around $35, then you need a data cable, laptop, and chip burner and you are ready to rock. Or you can just pay someone else to do it for you.


All times are GMT -5. The time now is 03:16 PM.
Page 3 of 3
1
2
3
Show 40 post(s) from this thread on one page


© 2024 MH Sub I, LLC dba Internet Brands