Can someone Identify This conversion harness??
 

Yeah I'm getting some wierd cel problems and I need to make sure everything is right.
the xenocron wire color instructions don't match neither do rywire or boomslang.
Anyone know what brand it is?

https://publish.hometown.aol.com/dwm...es/harness.jpg

Re: Can someone Identify This conversion harness??
 

jdmshit

Re: Can someone Identify This conversion harness??
 

chingchongmeow.com

Re: Can someone Identify This conversion harness??
 

---- wire color instructions.

When you are looking into the harness where an OBD1/2 distributor plugs in, it is the same as looking at the backside of the B-plug.

B11 B13 B15
B12 B14 B16


I forget if the IGO pin and blank spot are on the right or left, just orient the release tabs upward and it'll work out fine.

Re: Can someone Identify This conversion harness??
 

the distributor is good. this harness had a few cut wires on it between ecu plugs and I'm trying to decide what to do with them. one was A26 on the obd1 plug the other was A23

Re: Can someone Identify This conversion harness??
 

Two black wires T into them and go to the subharness. I think those would be used for ground if your running obd1 injectors with no resistor box. as of right now I have them both grounded on the tstat housing. I'm thinking of just cutting them. they should be grounded in the cars harness maybe it;s just redundent having then grounded again

Re: Can someone Identify This conversion harness??
 

A23/BLACK - ENG. GROUND (THERMOSTAT)/ PGMFI MAIN RELAY PIN 3
A26/BLACK-RED - ENG. GROUND (THERMOSTAT)

Re: Can someone Identify This conversion harness??
 

Yeah thats what I figured to Buk.
I had another harness in my basement that I snagged from the junkyard. So I swapped it in and the cel's went away It must be a short somewhere in the harness so Where ever the problem is I don't feel like cutting through all that hot glue to ---- with it ,oh well I'm just glad my other harness worked.