Re: Anybody here no anything about carbs?
 

Well the bitch is there is close to a 100 pieces and parts.I figured the piece of ---- out though just had to adjust the float level via the adjustment screw on top of the carb :1 Grabbed a rebuild kit today and will take it off and rebuild it next weekend for some practice and to get it dialed in for winter use.

Re: Anybody here no anything about carbs?
 

dam I forgot about that, its been a long time since I fucked with one of those. :1

Re: Anybody here no anything about carbs?
 

get some cleaner too, the bowl might be varnished up and the float could be sticking.

Re: Anybody here no anything about carbs?
 

Ya i will def clean the ---- out of everything when i rebuild it.There is a big screw on top of the carb that i thought was the mixture screw but its the float level and i think I adjusted way to far out when i was ------- around :1 Now that i found the mixture screw on the bottom i leaned it out a bit and it runs better already.This carb is a 3 barrell or that is what its called as it has two barrells one primary and then two stacked on each other for the secondary as it pulls the top one open with vacum i believe when you hammer on it :S Good learning experience as i have not fucked with a carb in years.

Re: Anybody here no anything about carbs?
 

if it's an actual holley then yes, that's right. but there's only about 26 parts to a holley 2300 :)

Re: Anybody here know anything about carbs?
 

No it is a Keihn i believe its spelled.I think most Honda carbs are made by them.There is literally 50-100 pieces alot tiny little better not drop it or you will never find again type pieces :S

Re: Anybody here know anything about carbs?
 

haha, just stick a small pipe with a needle valve in it, velocity stack it on one end and weld the other to a flange for the manifold.