65$ TullosTech DIY electronic boost controller
#16
Re: 65$ TullosTech DIY electronic boost controller
The problem in the past is that almost half testers never get around to installing the controller for about a year or so. So those willing to put a few dollars down, show that they actually want it and will install/test it in a timely manor. If you know how to solve this problem, let me know because I'm all ears!
This controller is not as accurate as my $400 boost controller, but ---- its does the job and cost considerably less. The controller has three lights (ON,Low Boost, High Boost) , boost switch, and two ***** for dialing in low/high boost. You can lock the boost settings by using the windows software and a usb cable, but thats not required to tune the controller. This controller will not solve boost creep like our TullosTech EBC. Its very simple to install and very simple to tune. Just turn the dial until you get the boost you want then switch over to high boost and do the same thing. I'm guessing tuning this EBC will take less than one minute for most. This design will work with GM solenoids and I'm looking into humphrey solenoids. If anyone knows some other good 3 port boost solenoids, please let me know.
I guess these guys will be on the market by Middle of May, probably before that. Like I said before, the hardware design is similar to our previous design... I doubt there will be any problems. I should have the EBC to my testers within two weeks and if nothing goes wrong we will be on the market two-three weeks after that.
Nick
This controller is not as accurate as my $400 boost controller, but ---- its does the job and cost considerably less. The controller has three lights (ON,Low Boost, High Boost) , boost switch, and two ***** for dialing in low/high boost. You can lock the boost settings by using the windows software and a usb cable, but thats not required to tune the controller. This controller will not solve boost creep like our TullosTech EBC. Its very simple to install and very simple to tune. Just turn the dial until you get the boost you want then switch over to high boost and do the same thing. I'm guessing tuning this EBC will take less than one minute for most. This design will work with GM solenoids and I'm looking into humphrey solenoids. If anyone knows some other good 3 port boost solenoids, please let me know.
I guess these guys will be on the market by Middle of May, probably before that. Like I said before, the hardware design is similar to our previous design... I doubt there will be any problems. I should have the EBC to my testers within two weeks and if nothing goes wrong we will be on the market two-three weeks after that.
Nick