what tee do i use for oil passage?
What tee do i use to tap into the oil pressure? and what oil lines do i use and where can i get it? I heard someone mention about summit racing? What's the part number?
3-wayT 1/8 NPT and Straight Union 1/8NPT ? What fitting do i use for the turbo? and where can i get the fittings? ;D And can these parts be found at auto part stores like NAPA, Kragen, AutoZone??? |
Re:what tee do i use for oil passage?
im not sure of the exact size, but NAPA has 'em
|
Re:what tee do i use for oil passage?
did you get yours there?
|
Re:what tee do i use for oil passage?
Well how about a bit more info?
Engine? Turbo? Not everyone has a honda here... :-* If it is a honda, 1/8 NPT is the thread pitch off the back of the block. you can then T into it with a Extension and splitter. Then however you run your oil feed is up to you, if you want to use a barb, or get a -an fitting. Jeff https://www.homemadeturbo.com/turbo/z61/oiline.jpg |
Re:what tee do i use for oil passage?
well i have a honda civic ;D With a B18a motor. So where can i find the steel oil lines? I have a T3/T4 hybrid turbo.
|
Re:what tee do i use for oil passage?
Braided line you mean? -an sized hose? You can get that through summit/jegs or a local race shop.
I would go with a -an 4 hose. The inlet for the oil feed on the t3/t4 is a 1/8 npt fitting as well. So its pretty basic stuff. you will need (2) 1/8 to -an4 fittings and the 3 way 1/8 splitter and a brass 1/8 extension. The brass fittings you can get at napa or local hardware stores. Jeff |
Re:what tee do i use for oil passage?
how much does all those cost altogether? what's fitting does the T3/T4 uses? the brass T extension is for the oil return to the oil pan?
|
Re:what tee do i use for oil passage?
Originally Posted by akirazian
how much does all those cost altogether?
Call around. Jeff |
Re:what tee do i use for oil passage?
what's fitting does the T3/T4 uses? the brass T extension is for the oil return to the oil pan?
|
Re:what tee do i use for oil passage?
I think you need to re-read my posts dude, I explain what you need for your oil feed, where to get it and how much it costs. I also state which size fitting you need for your turbo.
Oil return is a differnt story, you will need to get a Oil return flange, (drain) You can get one at http://www.roadraceengineering.com/f...andgaskets.htm 15 bucks w/ gasket, you will then need to weld a fitting in your oil pan. Then connect the 2 fittings together, with some basic rubber 5/8 hose, and hose clamp it. Jeff |
All times are GMT -5. The time now is 09:08 AM. |
© 2024 MH Sub I, LLC dba Internet Brands