What bends do i NEED?!?
 

ok my setup...1993 Hatch si w/D16z6 motor...IHI RHB5(i know small turbo...but this is my daily driver...don't need any lag :P) HF manifold...what bends do i need? and how many?...i'll be getting an fmic from johnnyracercar.com which is the 5 inch....so my question stands at what bends will i need and how many?

-DeL

Re:What bends do i NEED?!?
 

why the hell did you read the other post about the same exact thing, post in it, and then go and post the same question anyways???

https://www.homemadeturbo.com/forum/...threadid=16693

Re:What bends do i NEED?!?
 

well if you read what i said in the other post...i asked whats the difference between steel and aluminum...not what bends i need like i posted here...maybe you should read carefully before you flame! :o

-DeL

Re:What bends do i NEED?!?
 

pop the hood, pull the bumper, and figure it out for yourself. Nobody can answer this question for you.

Re:What bends do i NEED?!?
 

why is it when someone asks a simple question...ppl answer with smart@ss remarks...reason why i ask is because i don't want to buy too many charge pipes...if i wanted a stupid @ss answer i'd ask a clown!

Re:What bends do i NEED?!?
 

thats not a stupid ass answer. people set up their pipes differently, it would seriously take you 10 minutes to plan out your piping. look at other setups on the board/mainpage to see how to run them, then buy what you need.

Re:What bends do i NEED?!?
 

Jesus christ take a chill pill. If I asked you how to run charge pipes on my DX with a T3 mounted with the compressor exit pointing toward the front of the car would you know how to answer that?

No, you would not. Because only I would know after looking. I would have to consider certaing things such as the fact that my chassis doesn't have the 2.5" hole cut out where Cool air intakes usually go and so therefore I'd have to find ways around that.

So I stand by my original, honest, not intending to be a smart ass reply:

POP THE HOOD, PULL THE BUMPER, AND FIGURE IT OUT YOURSELF.

Re:What bends do i NEED?!?
 

Why is it when someone asks a simple question, gets an answer they don't like, then flips a ----? Seriously, how do you expect people to want to help you out if yer gonna flip out after they give your their answer?

EDIT: my bad, did not read stargazer's post :-X

Re:What bends do i NEED?!?
 

i know i need at least 3 pipes...but dam...you guys are just like some peeps on h-t who flame ppl for just asking a simple question...thats why i put in my setup so you guys know what turbo i'll be running on what motor...this is my first FI setup...i usually run N/A setups...and i already looked at the FAQ and didn't find anything...give meh a break!

Re:What bends do i NEED?!?
 

Dude they pointed you to the posthttps://www.homemadeturbo.com/forum/...threadid=16693 where i explained how many bends used for my set up.Read up and stop being an ------- when people are trying to help you.Dont be stupid...people wont help you if you piss them off!