What bends do i NEED?!?
#1
What bends do i NEED?!?
ok my setup...1993 Hatch si w/D16z6 motor...IHI RHB5(i know small turbo...but this is my daily driver...don't need any lag :P) HF manifold...what bends do i need? and how many?...i'll be getting an fmic from johnnyracercar.com which is the 5 inch....so my question stands at what bends will i need and how many?
-DeL
-DeL
#2
Re:What bends do i NEED?!?
why the hell did you read the other post about the same exact thing, post in it, and then go and post the same question anyways
https://www.homemadeturbo.com/forum/...threadid=16693
https://www.homemadeturbo.com/forum/...threadid=16693
#3
Re:What bends do i NEED?!?
well if you read what i said in the other post...i asked whats the difference between steel and aluminum...not what bends i need like i posted here...maybe you should read carefully before you flame!
-DeL
-DeL
#5
Re:What bends do i NEED?!?
why is it when someone asks a simple question...ppl answer with smart@ss remarks...reason why i ask is because i don't want to buy too many charge pipes...if i wanted a stupid @ss answer i'd ask a clown!
#7
Re:What bends do i NEED?!?
Originally Posted by Fallenegsi
why is it when someone asks a simple question...ppl answer with smart@ss remarks...reason why i ask is because i don't want to buy too many charge pipes...if i wanted a stupid @ss answer i'd ask a clown!
No, you would not. Because only I would know after looking. I would have to consider certaing things such as the fact that my chassis doesn't have the 2.5" hole cut out where Cool air intakes usually go and so therefore I'd have to find ways around that.
So I stand by my original, honest, not intending to be a smart *** reply:
POP THE HOOD, PULL THE BUMPER, AND FIGURE IT OUT YOURSELF.
#8
Re:What bends do i NEED?!?
Originally Posted by Fallenegsi
why is it when someone asks a simple question...ppl answer with smart@ss remarks...reason why i ask is because i don't want to buy too many charge pipes...if i wanted a stupid @ss answer i'd ask a clown!
EDIT: my bad, did not read stargazer's post
#9
Re:What bends do i NEED?!?
i know i need at least 3 pipes...but dam...you guys are just like some peeps on h-t who flame ppl for just asking a simple question...thats why i put in my setup so you guys know what turbo i'll be running on what motor...this is my first FI setup...i usually run N/A setups...and i already looked at the FAQ and didn't find anything...give meh a break!
#10
Re:What bends do i NEED?!?
Dude they pointed you to the posthttps://www.homemadeturbo.com/forum/...threadid=16693 where i explained how many bends used for my set up.Read up and stop being an ------- when people are trying to help you.Dont be stupid...people wont help you if you **** them off!