Hey Guys,
Here is the list of everything I have marked with an asterisk and everything I don't have.. well you get the idea..



-* T25 Turbo
- Turbo Manifold
- Turbo Studs and Nuts
- Turbo Manifold Downpipe Flange
-* Exhaust flange gaskets
-* Turbo flange gasket
-* Downpipe flange gasket
-* 2.5" Stainless Steel Mandrel Bent Exhaust System
-* T25 Oil Line Kit
-* 2.5" exhaust pipe gaskets
- 2.5" 2.5ft Straight pipe to replace Cat (Maybe resonator to replace -this?)
- 2.5" Downpipe
- 2.5" Flexpipe
- 2.5" Flanges for exhaust
-* 2.5" Intercooler Piping
-* 6" Front Mount Intercooler
-* 2.5" Couplers
- 2.5" T Bolt Coupler Clamps
-* 2"-2.5" transition
-* 450cc Injectors
-* Resistor Box
- Wire to extend to resistor box
-* Uberdata Chipping Kit
-* Solder
-* Datalogging Cable
- Spare Atmel AT29C256
-* Willem Eprom Burner
-* 2 5/8" Boost Gauge
-* 2 5/8" Oil Pressure Gauge
- 2 1/16" Water Temp Gauge
- 2 1/16" EGT Gauge
- Rubber hose
- 1/8" Pipe X 3/16" for vacum Manifold
- 3/8" Nylon T for Vacum from Brake Booster Line
-* EGT Probe
-* Steering Column Gauge Pod
-* GE Vaccum Manifold
-* TurboXS Blow off Valve
-* Turboxs Aluminum and Mild Steel Flanges for BOV
-* Full throttle Launch Safety Switch
- Innovate LC-1 Wideband
- Clamps for rubber hose
- Air Filter
- JBWeld
- Extra Oil
- Extra Coolant
- Connectors for tapping into water line

 

manifold and boost controller?

 

car?

 

Damn, looks like a pretty complete list you have going their.

Don't forget to get ---- like JB weld, oil, filter etc. Also, before you're done with it, check the condition of your current ignition system. If those are bad, replace them too. Looks like you've planned most of this out, but ---- will nickel and dime you once you actually start putting it on.

 

okay thanks for the advise guys.. I just edited the list and added a few items.. I forgot connectors for the water lines to the turbo..