WG project a success
 

ok I have a boosted b18c and because of the high CR I can only run like 4-5 psi and that’s hard when the waste gate on the turbo is set to 9psi. I tried just moving the wg so the flapper was open a little to the point that it toped out at my wanted boost but I didn’t build boost till 5000 so ---- that.

so what I did was cut open an old wg I had sitting around. it was set to around 9 psi too. once I got it open I just cut the spring down that was in side so there wasn’t as much presser on it when I welded it back together. and what do you know it worked I start building boost under 2300 and hit full around 2800 and it stop right be4 5psi ;D

Re: WG project a sucsees
 

U know 10psi is the minimum amount of boost right? >:D

Re: WG project a sucsees
 

not sure what you mean by that but i dont know how much i know...looks like i dont even know how to spell

Re: WG project a success
 

10 psi and less is weaksauce, in other words. Throw 12 psi at that bitch. lol

Re: WG project a success
 

yeah 12 psi with 10.5-1 compression sounds more like a bomb then a motor

Re: WG project a success
 

Most ignorant statement of the night fo sho

Re: WG project a success
 

what kind of fmu are u running?

Re: WG project a success
 

hahaha

Re: WG project a success
 

i dont see how thats so ignorant. the motor is all stock and has to last me for a few years. i know that if you tune it right you can run boost like that but all i can do right now is a little street tuning so for me i would say 12 is dangerous for my motor

as for fmu i have dsm 450s chipped ecu tuned with crome. i dont have the tuning tools my buddy does so i dont have a lot of time to run around tuning

Re: WG project a success
 

gsr's have 10.5 compression stock ?? p.s. i was running 14 psi on a b16 that 10.2:1 .. that was on a t3/t4 50 trim turbo an a safc for about 9 months with no problem i just sold the turbo and the car is still running :y