Turbo noob.
#1
Turbo noob.
hi. i drive a 98 ex with an internally stock D16Y8. im currently looking at a garrett t3 or t3/t4 turbo. im looking for no more than 250 hp, even though by the looks of it ill be around 200 hp. i was wondering if you guys could piece together a complete turbo kit for me, because i dont know how big this part needs to be to fit this part yada yada. thanks.
yes, ive done alot of searching. and money is a factor
yes, ive done alot of searching. and money is a factor
#3
Re: Turbo noob.
im a noob too...but no one here is ganna do your work for you....this site is so u can learn and do it your self..its where the DIY concept comes from...
easiest and cheapest way is to go with the junkyard kit....for example..you can figure that out on your own......
easiest and cheapest way is to go with the junkyard kit....for example..you can figure that out on your own......
#6
Re: Turbo noob.
buy welder, learn to weld,
make ur own mani, get intercooler,injectors turbo, bov, wastegate, ecu, and basically sit down and fab ---- up, i used a 2.5, piece of carboard pipe, to see if ---- would fit.
and visit www.howstuffworks.com and the section with all the tutorials.
make ur own mani, get intercooler,injectors turbo, bov, wastegate, ecu, and basically sit down and fab ---- up, i used a 2.5, piece of carboard pipe, to see if ---- would fit.
and visit www.howstuffworks.com and the section with all the tutorials.
Thread
Thread Starter
Forum
Replies
Last Post
sanjiyan69
Forced Induction
27
08-02-2006 11:07 PM
4thgenhothatch
Forced Induction
7
02-19-2006 09:39 AM