Pootie

Whats good HMT, i have this turbo . Its a little too small for my build and i want to sell. ( just want to see what it's worth, so i can price accordingly.



*.60 trim
*T4 Divided houseing
*3" Vband
*no shaft play, or leaks ( has a lil oil on the front cover from a leaking fitting that dripped some oil on the turbo itself) But no actual leaking comming from the seals of the turbo.

From what i was Told it's a rebuilt Air Reserch Turbo (300 miles) . And will support 500-550whp!

Perfect for a Mild Street/Strip car.

Perfect for a 81mm build, might be a bit laggy on a SOHC, unless it's got headwork and higher compression.

~on with the pix~









thanks for the help!

bigdaddyvtec

PM me specs on the turbine cover please... I*m looking for a .96 or 1.00 T4 divided exhaust housing for a Ptrim wheel...

Smith-02

$60 + shipping

BLAAST

0.60 is the A/R but what is the trim of this t04b can you measure the wheel diameter ?

Pootie

will do, i have to get micrometer and measure the wheel , maybe tomorrow. ( the Turbo is at the Shop in Bk, and i'm in Manhattan.I usually go to Bk on the weekends.)

2GeclipseRST

Didn't see this. Hmmmm.

Yes. Need specs! PM ME!!!!!!!!

Wouldn't lag on my car, that's for sure.

Pootie

wanted to check the wheel to measure it, but forgot the micrometer. so this will have to do for now.

2GeclipseRST

Hmm. Pm me if you're willing to sell. If the price is right, i might scoop this off of ya. If i slap it on and dont like it (also buying a stock rx7 turbo w/manifold for $80 shipped), no biggie. I'll make my motor like it. Large street port should do the job. I think i should have no problem spooling that quick with my engine as it sits now though.

Big Pipe

i got a t4
divided inlet 1.32 if you want it ni66er