T3 60 Trim on b16a
#1
T3 60 Trim on b16a
Ok, i have come to the conclusion that i dont want to set the next land speed record and am just looking for decent streetable power. I am debating between two turbos
T3 60 Trim, .63 a/r housing with 5 bolt pattern, external wastegate,
or
an RB20DET turbo, ball bearing, comparable to a t3, t28.
my concern is the upper rev range, 6000 to 8200. Will these turbos be able to support 8-10lbs all the way to redline?
Also, is 2.5" intercooler piping too big for these turbos?
T3 60 Trim, .63 a/r housing with 5 bolt pattern, external wastegate,
or
an RB20DET turbo, ball bearing, comparable to a t3, t28.
my concern is the upper rev range, 6000 to 8200. Will these turbos be able to support 8-10lbs all the way to redline?
Also, is 2.5" intercooler piping too big for these turbos?
#2
Re:T3 60 Trim on b16a
im running a t3 .48/.60 turbo. i hit full boost(6psi) at about 4000rpm ish. and it pulls till the rev limiter......the power used to drop off big time when my wg opened, but that was b/c i had no dumptube on the wg,and it was blowing HOT air(exhaust gases) on my ic . duh
Thread
Thread Starter
Forum
Replies
Last Post
FooK
Wanted
1
07-09-2005 07:14 AM
99CivicEX
Wanted
1
11-14-2004 02:45 AM
asdewq
Forced Induction
4
11-04-2003 02:58 PM