so my new headgasket got bent a tiny bit, what am i lookin at here??
forged ls/vtec setup, the headgasket got bent up a tiny bit (about 1/4 inch when sitting on a flat surface). it bent right on the front drivers side, around the headbolt hole and the crankcase ventilation passage. i used copper spray and put it together. the hg wasnt crushed in any way. i used arp studs and torqued to stock sequence/specs of 61 ft/lbs total. im not really worried, but some of my friends are yelling at me. should i be concerned? it wasnt bent around any of the cylinders.......
|
Re: so my new headgasket got bent a tiny bit, what am i lookin at here??
head studs r tq'd more then that.
|
Re: so my new headgasket got bent a tiny bit, what am i lookin at here??
helms says 2 steps, one of 22 ft/lbs, and a second of 61
|
Re: so my new headgasket got bent a tiny bit, what am i lookin at here??
yea for stock bolts...find out the right torque
|
Re: so my new headgasket got bent a tiny bit, what am i lookin at here??
With gaskets, it's OK if they bend some. It's not OK if you put a crease in one. If that happens throw it out.
^Ditto. Find the correct torque & sequence. |
Re: so my new headgasket got bent a tiny bit, what am i lookin at here??
Originally Posted by ghettoturbo
yea for stock bolts...find out the right torque
|
Re: so my new headgasket got bent a tiny bit, what am i lookin at here??
arp head studs for d16 is 60lb/ft, i believe its the same for b-series or around there...
|
Re: so my new headgasket got bent a tiny bit, what am i lookin at here??
Originally Posted by B16Drag
arp head studs for d16 is 60lb/ft, i believe its the same for b-series or around there...
most of the time studs are alwyas torqued less than bolts. i cant remmebre exactly what my arp studs in my old integra were torqued to i think 65ftlbs |
Re: so my new headgasket got bent a tiny bit, what am i lookin at here??
alright ill check around for the tq. im not gonna be running a lot of boost pressure with this setup, so im not worried about the head lifting or anything.
the headgasket was far from creased. when i had it up against the head on the dowel pins, it was flat. it just got a tiny bit bent up at the end |
Re: so my new headgasket got bent a tiny bit, what am i lookin at here??
it doesnt make sense y would stud be tq'd less then normal head bolts? i had my old z6 turbo with a y8 head, i called arp but i dont remember what they told me it was, but im positive that it was quite a bit more then stock.
|
All times are GMT -5. The time now is 12:44 PM. |
© 2024 MH Sub I, LLC dba Internet Brands