WTF

is there some kinda how to or pictures of this anywhere? i cant find em.. just wondering what parts you use and if theres a better place then others in the exhaust to put it. my turbo intake vac source dont work to good

91efate

i was gonna route it a little bit after the oil pan, but i've been wonder wheter i should us a 10an line to a steel slash cut tube or just do the slash cut tube then put some high temp breather hose(green type)

Slo_crx1

I actually used the stock valve-cover-breather-to-stock-intake tube or one of the tubes that usually connects the water lines together on the stock motor setup. Took my drill and drilled an angled hole and welded the tube in angled back, connected a line from that to my catch can and then to my pcv valve. This setup seems to pull a very nice amount of vacuum. Just make the tube long to dissapate any extra heat and you should be golden.

bumblezc

There was a HUGE write up on PCV on HT one time. Try searching there.

91efate

been there done that its pointless. too much opinions and not enough facts. not much about the slash cut method was said.