Shaft play Holset H1C
 

Hi there, I bought a Holset H1C from Lowerit and I want to know if the shaft play is excessive or not. Since I don't know much about shaft play, I ask to "expert" ;)

For me it look a bit big, but I i'm not sure... Does it worth 150$?

http://www.youtube.com/watch?v=LlQfxGeonoE

The last sound is axial play....

Thanks folks!

Feel free to flame, but answer my question before ;D

Re: Shaft play Holset H1C
 

There should be some shaft play even with brand new turbo's, there needs to be some clearance for the oil, BUT....there shouldnt be any in and out, and the shaft play on that turbo seems excessive.

Re: Shaft play Holset H1C
 

does it hit the compressor housing?
if you are ever around a semi or soemthing with a large turbo check the pay, sometimes it is like 1/4inch sideways but almost none in and out.
i would say that turbo is fine as long as it doesnt hit the sides, and doesnt have in and out movement.

Re: Shaft play Holset H1C
 

I think it will be fine. Put some oil in it, that will tighten it up a bit. If it spins freely and doesn't hit the compressor housing you're good to go.

Re: Shaft play Holset H1C
 

that in and out play is a bit worrisome. I've always heard that there shouldn't be any on a good working turbo

Re: Shaft play Holset H1C
 

Holsets are a big shaft turbo and are way more resilient than garretts. I say run it till it blows which will probably be a long way down the road.

Re: Shaft play Holset H1C
 

Thanks for the reply. I don't know if it will last, but i'll try it...

If it doesnt, it's very close to!

Re: Shaft play Holset H1C
 

It's supposed to be close.

Re: Shaft play Holset H1C
 

If the turbo has end play (in/out) it's worthless. I mean it's a good core, but rebuilding a turbo with end play calls for quite the project as more than likely there's wear to the wheel(s), bearing housing itself, and shaft. Anyone who tells you otherwise is simply wrong. Also, that much lateral play is too much. It's well over 0.5mm which is pretty much the accepted maximum for lateral play. If you can feel ANY end play by hand then it's too much, as the tolerances are so tight that you shouldn't be able to feel it at all. I know it's not what you want to hear, but best case scenerio that turbo is a core.

Re: Shaft play Holset H1C
 

my bad I didn't watch the vid before, that is excessive.