Props to Straight Line Specialities!!
#1
Props to Straight Line Specialities!!
Well my manifold kit finnaly showed up today! Its so nice, id say the wait was worth it for sure. Next steps will include, routing the dumptube into the down pipe, welding in bung for EGT probe, then mounting it all up to figure out what needs to be added to the exhaust cut out. After that ill be flanging the cut out, mounting everything up, and getting tuned. Cant wait to finnaly get this kit bolted up. Im thinking mid july at the latest.
#9
Re: Props to Straight Line Specialities!!
the kit comes with the manifold, downpipe and dumptube.
My set up is
D16z6
SLP manifold
Slp 2.5in down pipe
QTP exhaust cut out
Greddy RS BOV
2in hot side/2.25 cold charge pipes
CCA 6in FMIC
precision 680cc injectors
walbro 255 fuel pump
stealthmode oil lines
BLOX EGT,boost, Oil pressure guages
Greddy Profec B spec 2
silicone couplers and t-bolt clamps
GM 3 bar map sensor
Tial 38mm wastegate
Garret t3/t04e 50 trim with .63 turbine
I will be tuning for 12psi for the time being, keeping timing conservative, looking for about 250hp
Before the end of July most likly ill be droping in my vitara pistons and eagle rods, tuning for 22psi and hoping for around 350hp
My set up is
D16z6
SLP manifold
Slp 2.5in down pipe
QTP exhaust cut out
Greddy RS BOV
2in hot side/2.25 cold charge pipes
CCA 6in FMIC
precision 680cc injectors
walbro 255 fuel pump
stealthmode oil lines
BLOX EGT,boost, Oil pressure guages
Greddy Profec B spec 2
silicone couplers and t-bolt clamps
GM 3 bar map sensor
Tial 38mm wastegate
Garret t3/t04e 50 trim with .63 turbine
I will be tuning for 12psi for the time being, keeping timing conservative, looking for about 250hp
Before the end of July most likly ill be droping in my vitara pistons and eagle rods, tuning for 22psi and hoping for around 350hp
Thread
Thread Starter
Forum
Replies
Last Post
nyc86zc
General Discussion
15
09-17-2005 03:30 PM