problem with injector instal
#1
problem with injector instal
i know theres been a lot of stuff written about installing dsm injectors into hondas but i'm stuck. i just did my first install on my brothers sohc vtec hatch. got the injectors in with no problem.but i was really confused about the resistor box hook-up. what i'm not sure about is where to splice the injector wires. can i just splice the wires right there on the manifold(similar to using radio shack resistors) or do i need to splice it at the distrubition block like shown on other sites? because i did splice it at the manifold and the car won't even idle. i'm prettty sure the sires are hooked up right. the car ran fine before installing injectors on a fmu setup. any help would be great cause no one wants to pay a shop 100 bucks to do the install. thanks.
Thread
Thread Starter
Forum
Replies
Last Post
robs99si
Engine Management
2
05-31-2004 08:12 PM