crxtubo22

is anyone willing to help me with a print for an adapter plate for hf mani to t25 dsm turbo.i have full use of a machine shop and need to make up a few adapter plates any help plz.

shortyz

yeah can someone measure there T25 bolt pattern and HF..

i think i have a few i could make up some plates in autocad.

bounce

the 2.25 center hole seem ¼ inch too big ....

shortyz

is that a t25?

RENR

i think bmc gots this covered...

bambooseven

just buy one unless it's gonna be way cheaper to make it. but you're gonna need gaskets to install it, just use those to make the plate

Johnyquest

you don't really need to use gaskets, as long as the surfaces are relatively flat... once the manifold / plate / turbo heat up, they will expand and nicely seal any minor leaks.

crxtubo22

thax for the print bounce just one ? on the .406 dia hole are those the cbore dia. they seem big(i dont have a turbo flange or gasket to go by). im going to start working on it this week.Yes it will be cheaper for me to make one because metal= 0$ use the machine shop=$0 and about 3 hours of my time i think is worth imo.

thax for or time guys

bounce

.406 holes may be because the thread are on the turbo itself instead of the flange ... you cannot bolt it rignt if both have thread. well i did mine to these spec

boarder360j

is a hf and a std manifold bolt patern and hole size the same?