HomemadeTurbo - DIY Turbo Forum

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)
-   Forced Induction (https://www.homemadeturbo.com/forced-induction-7/)
-   -   Please help-- won't start (https://www.homemadeturbo.com/forced-induction-7/please-help-wont-start-50657/)

EG-prince 11-23-2005 03:43 PM

Please help-- won't start
 
Hey, I'm fucked right now, so i hope you guys can help. I turbo'd my car yesterday and I can't get it to start. It cranks but there's no spark, and the sparkplugs come out covered in gas. What could cause this to happen and how do I fix it? Setup is: Greddy turbo, mani, and bluebox, type s bov, stock injectors. I know that blue box and stock injectors is ----, i just need to get it running, and i'll stay off boost until i get my ecu chipped. I'm pretty sure the blue box is hooked up right, but before i hooked up a resistor box for the dsm 450's but when it wouldn't start i figured it was giving too much fuel, so i undid everything and put the stockies back in place, but would it matter if the yellow/black wires from the engine harness side didn't go to the right injector yellow/black wire? I think they are to the right ones, but even if they weren't i would think that at least two of the cylinders would spark. Please help :1

djfob 11-23-2005 05:54 PM

Re: Please help-- won't start
 
did you remove the plugs wires? incorrect firing order?

hotrex 11-23-2005 07:41 PM

Re: Please help-- won't start
 
sounds like someone needs to double check there wiring,

sounds like a ---- coil in your distributor to me.

EG-prince 11-24-2005 08:33 PM

Re: Please help-- won't start
 
So it turns out it was hardcore flooded, and i hope that was the only reason it wouldn't start. I dried it out but haven't tried starting it again yet. How badf is it realllly if the oil return line is below the level of oil in the pan? I put it as high as i could with the fitting i used, but when i put oil in the car before i attached the return line a good amount of oil came out the fitting. Is it okay to run for a while like this til I order a better fitting and maybe a new oil pan?

djfob 11-24-2005 11:12 PM

Re: Please help-- won't start
 
with the oil retun low it'll start backing up eventually blowing the turbo seals

Toysrme 11-25-2005 01:42 AM

Re: Please help-- won't start
 
If you're really lucky, once the engine is running it'll suck enough oil up to un-cover it under most conditions.
Try it & see. Just be ready to both take it easy & move it if you have too! GL with that LoL!


All times are GMT -5. The time now is 03:27 PM.


© 2024 MH Sub I, LLC dba Internet Brands