pcv system?
can anybody post pics and explanations of their setups for venting out the crankcase pressure on d series motors? I haven't found any good ways of doing it on a turbo D since it doesn't have 2 holes in the back of the block like the b series do for that fancy catch can setup. Right now all I have is a valve cover breather and I would like something better.
|
Re:pcv system?
everyone uses the breather, its fine just like that
|
Re:pcv system?
you sure? I'm really worried about blowby.
|
Re:pcv system?
i used a half crushed beer can with the tube from the valve cover going into it ;D
|
Re:pcv system?
lmao now thats ghetto.
|
Re:pcv system?
I used my sock.
|
Re:pcv system?
I made this breather tank out of a 2" dia aluminum tube and use some Alumnite welding rods,JB weld and couple of brass barbs and presto! got me a gansta bling... ;D
http://www.we-todd-did-racing.com/we...MXk1NDE%3D.jpg |
Re:pcv system?
here is a close up of the homemade breather tank. Alumite welding rods are poor man's ways of welding (brazing) aluminum. ---- works for me. ;D
http://www.we-todd-did-racing.com/we...MXk1NDE%3D.jpg |
Re:pcv system?
that is awesome, wicked man, but where does the line go to? i don't understand?
and where do you pick up those Blinging Aluminum rods? |
Re:pcv system?
I saw one guy on VW Vortech use a plastic bear that used to hold honey as one. But oh my god was it ever sweet. I will look for the pics.
|
All times are GMT -5. The time now is 06:38 PM. |
© 2024 MH Sub I, LLC dba Internet Brands