can anybody post pics and explanations of their setups for venting out the crankcase pressure on d series motors? I haven't found any good ways of doing it on a turbo D since it doesn't have 2 holes in the back of the block like the b series do for that fancy catch can setup. Right now all I have is a valve cover breather and I would like something better.

 

everyone uses the breather, its fine just like that

 

you sure? I'm really worried about blowby.

 

i used a half crushed beer can with the tube from the valve cover going into it

 

lmao now thats ghetto.

 

I used my sock.

 

I made this breather tank out of a 2" dia aluminum tube and use some Alumnite welding rods,JB weld and couple of brass barbs and presto! got me a gansta bling...

 

here is a close up of the homemade breather tank. Alumite welding rods are poor man's ways of welding (brazing) aluminum. ---- works for me.

 

that is awesome, wicked man, but where does the line go to? i don't understand?

and where do you pick up those Blinging Aluminum rods?

 

I saw one guy on VW Vortech use a plastic bear that used to hold honey as one. But oh my god was it ever sweet. I will look for the pics.