not sure what happend.. thought i blew something?!?
Well... I got my turbo installed and only have a basemap on it... and you guessed it... I ran it fairly hard today. To put it as simply as i can.. I was at about 6-7k and it goes BOOM and a small cloud of black smoke goes out the back. Then it shuts off.
I originally thought that I either snapped a rod/ring lands were fried/ or bent a rod. However.. It cranks but wont turn over. SO I did a compression check. All are within 20 psi of eachother at around 180 (was like that before I went turbo). No really loud noises or anything when I go to crank it so I doubt its anything internal. (not sure tho). SO.. that kind of leads me to believe that its my timing belt. I thought my belt could have skipped some teeth or something. I took the valve cover off and couldn't tell much from there. Is it possible for the engine to do something like that and not start up? Or did I seriously fcuk something up? :( . After all of this is done... I will NEVER drive another car unless it is properly tuned. |
Re: not sure what happend.. thought i blew something?!?
cranks but doesnt turn over eh?
Aren't those synonyms? anyways, you can find out if the belt is broken most likely from pulling the upper timing cover |
Re: not sure what happend.. thought i blew something?!?
take a look at your plugs
|
Re: not sure what happend.. thought i blew something?!?
yeah Ill have to check the timing out tommarow...
as for the plugs, they all look fine. |
Re: not sure what happend.. thought i blew something?!?
turboed gsr motor w/ a basemap.........
^^ yeah, it takes like two seconds, literaly to check the tbelt or if it skipped. I would pull the pan and if you can see anything. |
Re: not sure what happend.. thought i blew something?!?
If the tbelt broke wouldn't get stuck and the motor wouldn't be able to crank over??
|
Re: not sure what happend.. thought i blew something?!?
I had similar effect when my ignition control modul died. Check if you have spark.
|
Re: not sure what happend.. thought i blew something?!?
thats for the good info thus far! I will deffinelty check if I have spark. Thanks a ton!
|
Re: not sure what happend.. thought i blew something?!?
So just a loud ass backfire and then nothing? Sounds like ignition to me, if you bent/threw a rod you would know it, if the compression is the same as it was than chances are your ring lands are fine.
|
Re: not sure what happend.. thought i blew something?!?
Originally Posted by Mugen112
thats for the good info thus far! I will deffinelty check if I have spark. Thanks a ton!
And if you snapped the t-belt you wouldn't have any compression :1 |
All times are GMT -5. The time now is 11:53 PM. |
© 2024 MH Sub I, LLC dba Internet Brands