new wastegate for my m43 garrett
#2
Re: just fabbed a 3 inch down pipe for my m43 garrett
Originally Posted by ndnnikk
should i run oil feed ristrictor for this garrett m43 57 trim
also why didn't you mount the turbine on the other side? would have used less bends and now the compressor is going to pull heat directly from the radiator
#3
Re: just fabbed a 3 inch down pipe for my m43 garrett
it bumped radiator fan shroud and i could have but i diddnt like the way the cut would have been on bend, i really wanted it other side, im run piece of charge pipe with filter
#5
Re: just fabbed a 3 inch down pipe for my m43 garrett
Originally Posted by EGgyLShatch
Good work on downpipe, gay intercooler
but yea IDK if you like it routed that way the work loks pretty damn good
Originally Posted by marcj
unless it's a ball bearing turbo, run an open -3 AN feed..
also why didn't you mount the turbine on the other side? would have used less bends and now the compressor is going to pull heat directly from the radiator
also why didn't you mount the turbine on the other side? would have used less bends and now the compressor is going to pull heat directly from the radiator
keep up the nice work on the build
#9
Re: just fabbed a 3 inch down pipe for my m43 garrett
IMO always better to run a restrictor than not. Is that the final placement for the gate?
Might want to try and get it looking after all four exhaust ports..just in the middle would be fine
Nice turbo btw
Might want to try and get it looking after all four exhaust ports..just in the middle would be fine
Nice turbo btw