...NEW video...D15B VTEC T3 SETUP---NOW MY CLUTCH LOL
#21
Re: LOOOOOK !!!! NEW VIDEO...NEW PROBLEM...D15B VTEC T3 SETUP
ok you were RIGHT!!! hex needed to be at 8000!!!! Thanks! OK now it runs great except at 50%+ throttle it dies and backfires...ONLY with a load mostly in 2nd gear. Help me solve this one too!
#22
Guest
Posts: n/a
Re: LOOOOOK !!!! NEW VIDEO...NEW PROBLEM...D15B VTEC T3 SETUP
*L* I knew it. Back when I got my burner I tore up an ecu thinking I had fried whe All it was was the damn chip addresses.
Did your CEL go away? disable the O2 in crome cycle the key and see if it comes back. If it does check the code and trouble shoot from their don't change the tune or anything yet until you do that. You have to try one thing at a time or you'll end up chasing your *** for days.
Did your CEL go away? disable the O2 in crome cycle the key and see if it comes back. If it does check the code and trouble shoot from their don't change the tune or anything yet until you do that. You have to try one thing at a time or you'll end up chasing your *** for days.
#24
Re: LOOOOOK !!!! NEW VIDEO...NEW PROBLEM...D15B VTEC T3 SETUP
Ok...the CEL goes away but 2 secnds after I start it, it comes back....In uberdata I have all sensors disabled and closed loop disabled...that's what I need for no O2 right? I will wire up vtec tomarrow morning. I never rewired my tps so it should be fine...I think it starts to cut out like that around when boost starts to really kick in?!?!?!?
#25
Re: LOOOOOK !!!! NEW VIDEO...NEW PROBLEM...D15B VTEC T3 SETUP
Its revs freely until rev limit (7500) when I'm in neutral with no load...its the worst in 2nd but it does it in all the gears if I'm on the throttle more than a little.LMK what you think thnks
#27
Re: LOOOOOK !!!! NEW VIDEO...NEW PROBLEM...D15B VTEC T3 SETUP
Originally Posted by PoweredT3A6
Its revs freely until rev limit (7500) when I'm in neutral with no load...its the worst in 2nd but it does it in all the gears if I'm on the throttle more than a little.LMK what you think thnks
EDIT: Why are you reving that high anyways...redline for a6 is at 7100 and z6 is at 7200. Unless you plan on running your redline up to 8k....
#29
Re: LOOOOOK !!!! NEW VIDEO...NEW PROBLEM...D15B VTEC T3 SETUP
Originally Posted by PoweredT3A6
But now I am using a different bin that was made for uberdata...not the **** bin...it's called My_final_Z6_tune.bin...