NEED ADVICE DOWNpipe problem
 

the way my mani sits, my downpipe barley wont fit cuase it hits the side of the radaitor fan shroute. Should i trim some of the fan shroute off or what should i do? its a 2.5 downpipe.. What do u guys think

Re: NEED ADVICE DOWNpipe problem
 

Slim fan to the rescue!!!!!!

I use a 12" slim in front of my rad as a pusher

Re: NEED ADVICE DOWNpipe problem
 

where can i get one? does it go inbetween the frotn bumper and the raditor or inbetween the radiator and engine where it normally is

Re: NEED ADVICE DOWNpipe problem
 

hows this http://www.d-series.org/forums/showthread.php?t=20831
or where can i get one that will fit right up

Re: NEED ADVICE DOWNpipe problem
 

Can't veiw the forum but I picked one up at the local napa store and one at the local speed shop. You can mount most universal rad fans as an either or postion. Between the bumper and the rad is a pusher setup like mine, you just flip the fan blades around and wire it reverse polarity. Between the rad and motor is a pull style (like a factory fan). You can pick these fans up for 35-45 of ebay to let you know.

Re: NEED ADVICE DOWNpipe problem
 

Meaning lol, how whould i wire it, i just pulled out my AC as well too

Re: NEED ADVICE DOWNpipe problem
 

if ti is only hitting the shourd. i`d rather cut it up ratehr than spending the extra$

Re: NEED ADVICE DOWNpipe problem
 

downpipe is gonna get kind of warm and if you just cut the shroud its still going to put out alot of heat right there possibly melting something you dont want it to melt

Re: NEED ADVICE DOWNpipe problem
 

pssh radiator fan? who needs em ;D nah i need to get one, ive been driving without one for a couple weeks :-[ whenever the temp slightly goes up when im in traffic i just pop on the heater and it takes car of it ???

Re: NEED ADVICE DOWNpipe problem
 

Wire it either to your stock connector to come on with the thermostat, or to be on constantly. When you get the fan It will have two wire (normally one black one blue from the most I've seen). Connect the black to ground and the blue to positive. See which way the fan is spinning(normally pull style from factory) If that is true and you want it pusher style(in front of the rad) Remove the blades (normally a bolt or c-clip) flip them over and then when you wire, put the blue to ground and black to positive. You should get instructions with the fan and even so, It FAR from rocket science, basic clockwise/counterclockwise motion and Positive/negative wiring.