My kit good to go?
#1
My kit good to go?
So after reading all these "what else do I need" posts, I thought it might be a good idea to start one of my own so I don't get stuck last minute needing something important so here is goes. After about 3 months of finding and ordering parts, i'm almost done piecing together the kit for the cavy. Just wanted to run it through here and see if anyone could find anything else I might need. I know I might need a few flanges/gaskets, but i'm not sure if i'll need them yet. Have to see what my parts come with. So far this is what I have or am about to order:
Garrett T3 .60 compressor, .48 exhaust Internal Gate(ordering tomorrow)
6'' JRC FMIC
2.5 Mild Steel Charge Piping, (4) U bends, (2) 3ft straight pieces
T3 Log Manifold
NGK TR6 Plugs
MSD DIS-2 to pull some timing
Oil Line Kit
(5) 2.5'' couplers and clamps
Extra Injector Controller (Greddy Rebic or SDS EIC..gotta find one used)
(2) Steel Injector Holders that will be welded into charge pipes
(2) DSM Blue Top 450cc Injectors
Walbro 255 LPH In-Tank Pump
1G DSM BOV (anyone got one?)
Dual Pillar Gauge Pod
Boost Gauge
Oil Pressure Gauge
Thanks guys, appreciated.
Garrett T3 .60 compressor, .48 exhaust Internal Gate(ordering tomorrow)
6'' JRC FMIC
2.5 Mild Steel Charge Piping, (4) U bends, (2) 3ft straight pieces
T3 Log Manifold
NGK TR6 Plugs
MSD DIS-2 to pull some timing
Oil Line Kit
(5) 2.5'' couplers and clamps
Extra Injector Controller (Greddy Rebic or SDS EIC..gotta find one used)
(2) Steel Injector Holders that will be welded into charge pipes
(2) DSM Blue Top 450cc Injectors
Walbro 255 LPH In-Tank Pump
1G DSM BOV (anyone got one?)
Dual Pillar Gauge Pod
Boost Gauge
Oil Pressure Gauge
Thanks guys, appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
spooolin
Turbo Parts For Sale
13
12-27-2006 03:00 PM
linkmustang
Turbo Parts For Sale
9
12-06-2005 08:09 PM
ssl2k
Engine Management
6
10-31-2004 01:55 PM