manifold modification question
#2
Re:manifold modification question
youd probably have to use a hole saw as it may be hard to find a chuck large enough to fit a drill bit that size. What do you mean by oxidation? Surface rust? If the manifold is cast it will be really hard to dril through it. Good luck
#4
Re:manifold modification question
yeah, I was going to use a hole-saw to make the cut. And then use a hand held grinder with a wire wheel to clean off the surface rust. Would having the manifold sandblasted be better than wire wheeling it?
Thread
Thread Starter
Forum
Replies
Last Post