onlyflash944

yea, just not hmt sponsors mr. golden eagle and msd



for real, good luck with your goal, looks like you got your stuff together

solorex

cool ----, I wish I had your budget .. ---- the haters they have never seen over 300 whp :1

rudebwoy

xenocron is HMT owner and sponsor correct? and I am pretty sure with all the cheap skates that he deal with on here, my cheapest order is more than most of the members here spent on their whole project,
stealthmode oil line supplier. plus other lines I have in mind.
tuner toys, its been while but yeah I supported him.
FJ all my bearings and studs
I've supported spoolin maybe before he was hmt sponsor but I did.
the other sponsors that don't supported is because they don't have what I am looking for, too expensive, don't ship to APO addresses or charges international for APO shipping. next I tried my best to not support the chinese market , yes my radiator and intercooler is chinese but they were cheaper from CX. so


so if my project goal calls for a sleeved block and a HMT sponsor don't carry I should not run because golden eagle is a H-T sponsor, and HMT don't support hondata so I must run a vafc hack.
I work very hard for my money daiy never collect any unemployment or handouts. I even duck bullets every once in a while, so please! I just thought that I would share my project with the forum I've been a member on the longest and spent the most time on. I just don't appreciate the hating. people who work hard deserve good ----. I don't wan't a junk yard turbo setup so I won't buy one.

lilpooh21186

^^^^ much respect quailty parts doesnt mean your not hmt to the bone.

rudebwoy

man o man o man! all this ignition talk.
someone could have told me that an ls distributor does not bolt up to a b16 head :1 :1 :1 . but because I am a geeeenyussss it took me 2 seconds to figure out a solution, just swap the internals to a b16 distributor shell.

running into some problems here and there, no fuel in # 1 cylinder gotta check my injector wiring, I sure hope my injector is not dead. they are almost new.

integrals21

nice set-up you got...its boost...forget the hating

rudebwoy

Progress on the exterior. just order all the replacement body parts for it. new front and rear bumpers, right fender, and rear quarter panels.
I don't like to have a nasty looking car, and my rear quarter has lots of hidden rust, bumper cracked, front cut for fog lights, I wanna go back to stock.
so thats it for cosmetic stuff on the outside. interior is done.

rudebwoy

another delay in my project. car wouldn't start so I started trouble shooting. found out I am not getting fuel in #1 cylinder so started checking my wiring and couldn't find any problem in the wiring, continuity and voltage checked out good. I checked everything from ecu to wiring to fuel everything good.

then something came to my mind . switch #1 injector with #2 injector, did that and turned out that the #1 injector is not working. don't know what caused it to stop working.
but I hope xenocron, or PTE will honor me by replacing it I own the injectors less than 1 year. I can't afford to buy another set now. but if I do I am going to 1600cc

seerex

Damn so close to being done. How many miles on the injectors?

rudebwoy

maybe 1500 miles