is there any directions of installing a turbo setup? like where oil lines go and where vacum lines go...stupid question to some of you...but helpful to others (like me) i have never delt wit turbo so im a n00b at it..i've always been n/a but imma do turbo and try it out for awhile..any help would VERY be apriciate it

my setup will be a bmc manifold, t25, 3inch dp, some kinda BOV, 3inch exhaust, and johnny race car FMI, fmu, stock injectors, and a 255 walboro..i have pretty much all the lines and hoses i think..just thought i'd let you all know in case u need to.. and it will be on a b16

 

Goodmorning , man all the help u'll ever need is right here on HMT 'yo !!!
I can supply you with this it might help you out a bit
Good luck with install

http://forums.cjb.net/ziptieturbo-about7.html

 

Sounds like you need to do a lot more reading before you attempt an install. The FAQ's are a good place to start.

 

read the stickies please

 

do not install a fmu on a b16 let alone any motor.

 

Quick!!! read the FAQ before someone flames you.

 

 

You are not worthy of a turbo!!!!! Go supercharger you'll be able to get like 900 hp on 10 psi. Trust me, I know that you know this, you know?

 

Be funny if he did follow your advice. Last time i told a guy who started to boost, to run 15 psi on stock internals with no management. He actually listen to my advice and did it. Before you know it. Boom! And i was just kidding too.

 

good learning source.
http://www.beesandgoats.com/boostfaq/g2icturbo.html