info on map sensor
Hi guys,
i still have problem with my map sensor, but i think i know why. I'm boosting 8 psi on a D16A6, with 450cc and SMC+. But i'm at -20% of correction at 8 psi and this is my problem. Zip( the guy who sold me the SMC) told my to check the signal of the map sensor at position ON II with motor off and i should have 2.8 to 3 volt. I have 3.3 so i change it but i have the same signal with the new one. So i need to know what is the real signal?? Thanks |
Re:info on map sensor
The real signal will be the ouput coming right out of the map sensor. (before the smc)
anything over 3.1v's the Map sensor CEL code will trigger. Jeff |
Re:info on map sensor
Originally Posted by AbaZ
The real signal will be the ouput coming right out of the map sensor. (before the smc)
anything over 3.1v's the Map sensor CEL code will trigger. Jeff But what about the signal with the engine off??? Zip tell me that supose to be 2.8 to 3.0 volt. but i have 3.3 volt. this is normal?? Thanks |
Re:info on map sensor
i dont know how his controller works, and I have no experience with it.. you may just want to keep contacting him..
yes, with the car on.. Jeff |
Re:info on map sensor
ok thanks a lot jeff.
Just another little question. I bought a Fuel pressure regulator yesterday. If i increase the fuel pressure, so i will decrease the fuel from the SMC so it soppose to decrease the signal of the MAP sensor... What are thinking about this??? Thanks a lot |
Re:info on map sensor
I'm thinking you wouldnt need a adj fuel pressure regulator with the SMC, but I dont know how well you can tune with it, since I have never used one..
Jeff |
Re:info on map sensor
i dont know how it works either but basically you can control the fuel pressure with it. however when u go into a closed loop thats when you read your map sensor on the ecu.
open loop you can control. i think correct me if im wrong |
Re:info on map sensor
ok, but it's not normal that i'm at -20% or correction on 450cc with 8psi of boost. it supose to be around -32 to -38%. So i think it's for this... I'm too low in correction so the signal of the map sensor is not modified enought to don't have a cel 3.
It is me that i'm affraid of run lean??? because on my air/fuel, i'm in the 3 first green light of rich at -20%. |
Re:info on map sensor
bump
|
All times are GMT -5. The time now is 02:21 AM. |
© 2024 MH Sub I, LLC dba Internet Brands