I'm having problems holding boost.
Hey guys, i have a mbc set to 8psi,and it hits it for about 4-5.5OOO rpm. but after that i lose about 3 psi, and i run super rich.
my questions are where could i be losing boost? i have a greddy 15g on a b16a. my thoughts were get a new actuator? maybe the charge pipes or intercooler are bad? wehere else could i be losing boost? pics here.. thank you. http://www.hybridhut.com/phildo.htm |
Re:I'm having problems holding boost.
sounds like a leak.. what are u using as a filter on the inlet?
|
Re:I'm having problems holding boost.
i bet its that tiny ass turbo
|
Re:I'm having problems holding boost.
yeah this is the guy runnin sohc greddy kit on a b16a, theres ur first problem....turbo is way too small, and fal out of it efficiency range at higher rpms...
|
Re:I'm having problems holding boost.
That turbo probably isnt the problem, I had the exact same problem when I ran with my S/DX exhaust. My cat was stopped up from a few qaurts of oil.
Nick |
Re:I'm having problems holding boost.
I agree, sounds like there is something leaking. I have a turbo for a SOHC on my B16 too and it runs out of air, but the boost level never drops, I just runout of power on the top end...
|
Re:I'm having problems holding boost.
nice to see another cornhusker on H.M.T. :)
|
Re:I'm having problems holding boost.
Nice looking car.. Check for leaks around the couplers. Use some soap ;)
|
Re:I'm having problems holding boost.
thanks for the replys ill check the piping couplers here in teh next few days. its kind of hard to now. since its 2 degrees out. with 6 inches of snow on the ground.
|
All times are GMT -5. The time now is 03:04 PM. |
© 2024 MH Sub I, LLC dba Internet Brands