IHI on DOHC engines
i found a IHI turbo off a auto turbocoupe. no shaft play at all and spins real nice with my fingers. what do you guys think about it on my b18a1.
the other turbo i had was bigger and spooled completly @ 2.5k rpms. so i dunno when this will spool prob 1.5k lol. its a t3 flanged IHI... any thoughts about it on a 1.8l DOHC engine? |
Re:IHI on DOHC engines
that turbo is rediculously small for a b18 in my opinion..i had one on my d16 and it was too small for me
|
Re:IHI on DOHC engines
noone else?
|
Re:IHI on DOHC engines
Should not have to worry about blowing it by over-reving...rotflol...
BTW... I have one which I considered also for low boost only. -Sam |
Re:IHI on DOHC engines
thats a ford t-bird IHI, its bigger than the mazda/subie one. i say you give it a try or sell it too me cuz i need one for a D16Y8 project....
|
Re:IHI on DOHC engines
ive used the subie one on my b18 91 integra, spooled completly to 8psi by 2300 rpm. lost a little up top, but it was a GREAT turbo to just drive around with. fells alot like a higher hp b18. there is almost no perceptable lag at all. i say go for it, its fun.
Brett |
Re:IHI on DOHC engines
I say go for it too.
The bigger IHI in the T-Bird can run at 15psi all day long on a 2300 cc so I'm sure it will work fine on a 1.8. That car came with either of two turbos, a T3 with I believe 60 in/63 out or the IHI, the IHI had a lot less lag and delivered almost as much HP. Good luck Neil |
Re:IHI on DOHC engines
Hey Random,is that the one you have on Ebay with the "Do not bid" on it? That made me laugh.Why not just remove it off Ebay?
I can have my wife tell you how to remove it if needed couse I shure as ---- dont know! |
Re:IHI on DOHC engines
yeaht hats me i dunno how to take it off rofl
|
Re:IHI on DOHC engines
The T bird IHI is the IHI RBH 52
|
All times are GMT -5. The time now is 03:18 PM. |
© 2024 MH Sub I, LLC dba Internet Brands