bitchasscracker

ok from what i read there are two different exhaust housings on these ******* the (12 cm^2 ~= .63 AR, 16 cm^2 ~= .82AR) but how do you know wich one you got ?


mine is the hx35w if it matters

CRXDrew

its been a few months so all this info isn't fresh in my mind but... isn't it stamped on the housing? And IIRC there are more than just two variants of housings. forgetting the 21^2 :-p

Sorry... not really helpful right now.. in front of someone else's computer right now.. I have more holset links marked on my comp. I'll chime back in later.

bitchasscracker

sweet you know where its stamped on the housing

CRXDrew

I meant cast.. not stamped. Should be clearly visible on the turbine housing.... I think... lol... lemme go check the spare housing I have in my room....

yep lol, right on the face of the turbine housing.

bitchasscracker

mine says

*12*
*e4-01-164* i think

klyph

Are you asking if you have a 12cm or 16cm when it says "12" on the housing?

bitchasscracker

it says o8h7c8 as well does that mean i got a supper special o8h7c8 housing from outerspace ?? :1



i have no experience with these turbo and was wondering where the identafing numbers were and what they ment.


and you are just a faggy butt ****** who drinks his own moms brest milk while your dad jerks you off

aero

Most of them have the size cast into the housing just inside the inlet flange. Its also normally on the outside near the flange also. Sounds like yours is the 12 for sure.

bitchasscracker

yea that is what i was thinking/pretty sure of.


but its on the outside of the turbine housing on the side facing the comp

CspecRun