Contimplating a new IC and I fiqured with 350whp I might as well do it right and get a 12" High.

How well will this squeeze into my EG from end, What about my EF when I'm done that chassis.

I know it's a newb question, but I don't care.

 

I have a CCA 31x6x3 on my EF and I did minor cutting of the bumper.





So, You would be looking at some cutting and Fab work.

 

Well My last intercooler I fabbed myself was a 6" so I know that.
In no way am I going to run no bumper support. I'm almost 100% sure I'm going to get it, and make myself a customer bumper support.

 

my boy runs the 31x12x3 in a rex, the ---- goes all the way up to the rad support. There is no chance you'll be running a bumper support. Weld a bar in there and call it a day. Cant wait to see your ---- running

 

no way you can run a 12" tall fmic on a eg while retaining the bumper support.

 

I don't want to RETAIN the support. I will re-fab one. Just wanted to know if it would clear all things up top like the rad support and such.

 

i saw an ek with a 12". the guy actually had to cut a hole on the top of his bumper to accomidate. if you were to look at the car head on, you couldnt see the H emblem

 

get a 9 inch and your golden
all you have to do is cut the bottom part of the bumper support and slide it in
bolts to the top part of the support, perfectly
The IC I am using is a perfect fit in an eg 4 door.