HomemadeTurbo - DIY Turbo Forum
Page 3 of 3
1
2
3
Show 40 post(s) from this thread on one page

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)
-   Forced Induction (https://www.homemadeturbo.com/forced-induction-7/)
-   -   How hard is the o2 sensor screwed on there? (https://www.homemadeturbo.com/forced-induction-7/how-hard-o2-sensor-screwed-there-46906/)

con 10-01-2005 10:53 AM
Re: How hard is the o2 sensor screwed on there?
 
Originally Posted by Spenser
Originally Posted by hmtcrxsir
They didnt invent the O2 Sensor socket for nothing. ::) just get the one that is 1/2 socket and use a breaker bar and that O2 sensor should be out in no time.
you're obviously a dumb ---- since those shitty o2 sensor sockets will break/strip the o2 sensor if you put any sort of force on them. faggot.
Ya Spencers right, I have a Snap On one and it also ------s. Cut the wires of and slide a box wrench or deep socket over it or you will strip the ------- thing.

Ravage70 10-01-2005 03:10 PM
Re: How hard is the o2 sensor screwed on there?
 
or

u can cut the tab off the grey piece that holds the clip on that little metal tab/bracket

then the remaining connection should go through a 7/8" wrench with a bit of fussing

96_civ 10-01-2005 04:46 PM
Re: How hard is the o2 sensor screwed on there?
 
try puttin the wrench on it, and hittin the wrench with a rubber mallet, a few fast quick taps should break it loose (after you heat it up) if you dont have a wrench just let you car run for 5 mins, and watch your hands so you dont burn the hell out of em.

then once its out piss on it and call it names and tell it how much it was pwnd.

matt


All times are GMT -5. The time now is 09:00 AM.
Page 3 of 3
1
2
3
Show 40 post(s) from this thread on one page


© 2024 MH Sub I, LLC dba Internet Brands