NEW PICS AT BOTTOM....


how the hell do you connect the supplied end that auto meter gives you for a boost gauge to a regular vacumm line or reg t?? it's a brass fitting and i have it kind of connected to a universal 'trim to fit' t and sealed with duct tape :P

 

that's funny as ---- that you say that because thats' the same thing I did. It's such a ------- pain in the ***, they were so dumb when they came up with this.

 

I'm also having the same problem. I was thinking about t-ing the fuel pressure regulator line, then use a little piece of hose and slide it over the boost gauge line and zip tying over it.

Stan

 

yeah, i was kind of thinking the same thing, like get some thick vacuum hose like used on the brake booster, but that's still ghetto to me, auto meter sucks my ***.......

 

I made a T with brass fittings from Homedepot, One to screw in the line from the gauge, and 2 sides with barb fittings to connect the vacuum

 

sounds good, i'll go check them out tonight. where do you actually find these fittings at home depot, plumbing? we just got one in my city about 3 mos. ago :P

 

Go to pep boys or advanced auto, they have a little adapter that you can buy. It's a little black rubber thing thats in the same section where you got your tee. It's just a little black rubber piece that you stick the vaccum line in and connect the other end to the tee. You just throw away that brass ----.

 

really? you it adapts that think clear vacuum hose to a regular t? i'll have to look for that as well, hell, either one is better than the duct tape, i can't believe that ----'s not leaking

 

I did the same thing, but damn was it ugly. That ---- is way bigger than it needs to be.

If Pep boys or Auto Zone sells an actual fitting that connects direct, I would go for that. That brass setup is ghetto and I know you don't want any ghetto styles under your hood.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

 

on the back of my z6 intake manifold, i had an extra vacuum port for the purge solenoid, and i just put a piece of extra large ricer vacuum hose on it, and the plastic flex-o-hose that came with my boost gauge fit right inside of it. I'm boosting psi and it hasnt shot out or anything