goofy t3
#1
goofy t3
have any of you guys worked w/ that goofy chrysler t3's 3 bolt inlet flange i'm thinking about using the stock inlet tube thingy and just blocking off the egt opening, but i can't think of any thing else to do. any ideas?
#4
Re:goofy t3
relentless racing used to offer a new inlet, but they are no longer around. soo...
cut it and jbweld it and you'll be fine.
here you go: (scroll down to the middle of the page)
http://fwdmopar.50megs.com/exhaust_turbo.html
cut it and jbweld it and you'll be fine.
here you go: (scroll down to the middle of the page)
http://fwdmopar.50megs.com/exhaust_turbo.html
#6
Re:goofy t3
why dont you just get another 50 trim compressor cover? You should be able to find one thatll work for you, some of them have a short straight section of pipe cast in that you can fit a coupler over for your intake pipe, like a saab turbo.
#7
Re:goofy t3
check out these flanges, they are 3 hole for 2", 2 1/2",3" inlets. you could weld a piece of charge pipe on it and clamp down an air filter to the charge pipe.
link:
http://www.jcwhitney.com/autoparts/P.../p-921/c-10101
link:
http://www.jcwhitney.com/autoparts/P.../p-921/c-10101
#8
Re:goofy t3
Originally Posted by trebor_nordap
check out these flanges, they are 3 hole for 2", 2 1/2",3" inlets. you could weld a piece of charge pipe on it and clamp down an air filter to the charge pipe.
link:
http://www.jcwhitney.com/autoparts/P.../p-921/c-10101
link:
http://www.jcwhitney.com/autoparts/P.../p-921/c-10101
Thread
Thread Starter
Forum
Replies
Last Post
bitchasscracker
Engine Management
3
01-03-2008 01:44 PM