first drive of the GRM car.....errrr wtf.. Help a brother out
got it running last week, finished all the suspension today and brakes and finally drove it.
starts well , idles fine.. but has a wierd stumble at about 4K (I never took it higher) here is my setup D16Z6 450's DSM with resistor box Xenocron basemap 2.5" exhaust , no muffler. Ching chong intercooler stock MAP RB25 turbo Vitara's I drove it around the block once and it would die under load , I could def. hear the turbo spool , but 35-4000 rpm it just died , and even back fired once. all the BS recirc vacuum ---- is gone , just vac lines from the waste gate to the intake , BOV and Adjustable regulator. I have yet to install the pressure gauge at the rail , if the fuel pressure was too high would it cause the car to run rich?? I didn't get a change to put my wideband in yet , but wanted an idea of where to start.. We leave for flordia next Wed , car goes for paint on Monday. Thanks JM |
Re: first drive of the GRM car.....errrr wtf..
OK
|
Re: first drive of the GRM car.....errrr wtf.. Help a brother out
I had similar problems because of grounds being damaged or missing.
Also when you hooked up the injector box did you make sure all your connections are good. Just in case and this maybe a long shot, but you preload the timing belt before tightening the tension pulley. I have had the cam gear jump 1-3 teath that way. |
Re: first drive of the GRM car.....errrr wtf.. Help a brother out
so is it limp mode or not?
|
Re: first drive of the GRM car.....errrr wtf.. Help a brother out
bad plugs,wires is your speedo working? could be in launch controll. any engine codes?
|
Re: first drive of the GRM car.....errrr wtf.. Help a brother out
plugs are new , wires are taylor 8mm jobbies , resistor box is good , no codes..
Does the speedo not working affect the motor??? (it doesn't work , not connected) I worry that the Fuel press reg is cranked up too high. I have a gayge for the rail , still need to install it. |
Re: first drive of the GRM car.....errrr wtf.. Help a brother out
if the ECU isn't seeing vehicle speed it never knows to turn off launch control.
try turning off/up FTL and see what happens |
Re: first drive of the GRM car.....errrr wtf.. Help a brother out
Originally Posted by onlyflash944
so is it limp mode or not?
|
Re: first drive of the GRM car.....errrr wtf.. Help a brother out
Originally Posted by myAE86turbo
how do you diagnose limp mode?
|
Re: first drive of the GRM car.....errrr wtf.. Help a brother out
Originally Posted by myAE86turbo
how do you diagnose limp mode?
|
All times are GMT -5. The time now is 02:49 AM. |
© 2024 MH Sub I, LLC dba Internet Brands