may be rough but i assure you no air will be getting through. its a stick welder. Ill have some updated pics tommarow of more charge piping and my ic.

 

Stickwelding thin wall - hrmph.

Anyway, I promise you if you were to cap an end and put some pressure in the tube it'd leak. You've got pinholes everywhere. I am not criticizing you, just telling you that it'd be better to grind it downa nd run a proper MIG bead now rather than later. I've welded a few times



I had to use a gasless MIG (Flux core) wire feeder once and I layed a smoother pile of booger welds than what ya have picture, and that damned thing leaked so bad - I know it seems like you've "saturated it with metal" but its really just cracked and pin holed. Good luck with it though.

 

there was more than one layer of weld put on. i dont think it will leak. I have looked pretty close at the welds and the inside of the piping. its fine

 

nah...I'm just messing around. I have no problem with anything.....


Do a test with air....cap one side close and put some air using a compressor or something. Some holes are small enough you won't see them, but they are there. Maybe even try water, see if it leaks out a little. It's better to check now than having to get it all out after it is done....


and where's the pics....post them up.

 

Yeah another trick is to cap one end of the pipe and pressurize it and spray it with soap water over the welds. Pin holes aren't something you can really see. It's a pain in the ***.

 

water test would be good.

I swore that this one weld i did was sealed, and the water test proved me wrong. grind everything smooth, then go over it again.

 

ill have the pics up later tonight. I Have to type a 3 page paper for world issues first. haha. i am going to cap one end. fill it up with water, and see if there are any holes in the intercooler piping. hopefully i have lucked out.

 

No you don't It's simple.





The US is right and always will be. Cause we'll nuke you bitch!

 

here are some pics from tonight. still didnt get the z6 started. the dizzy order was pry messed up or some ----. too cold anyway.


Actually 2 brackets on top and 2 underneith. this intercooler is mounted right and isnt ------ rigged either like most of them on here. heh






intercooler piping so far.


an idea of how its gonna be.


whats your opinions nignogs?

 

looking good man but definetaly do a leak test before you get it all setup, i used a stick welder on a couple of my pipes and ended up having massive leaks and using a coupler over the welds as a bandaid