NGK or OEM if you are running stock ignition system. if you are running MSD or any aftermarket high performance ignition system MSD wires are the only way to go.

 

I like the MSD wires, not a bad set. I'll never buy another set of Nology's though...burned a set out in less than 2 months on my old d-series :P

 

Friend had the same problem. After a year or so they just burned up. Wonder what's the deal with those wires.

 

don`t buy them, MY CAR was used as a test car before these guys imported these CDM wires and i am telling you, THEY DO NOT FIT TOO WELL. some wires are to short and the plug is too long so the hole is semi-exposed.

 

Not exactly sure. I also had a big problem with the spark blowing a hole in the side of the insulator boot and causing misfires like crazy. Took me a few hours before I finally found out the problem. They might've been ok if they used a good insulator (like ceramic) instead of some cheap plastic. Even with a roll of electrical tape wrapped around the boot it still managed to burn through. :P

 

ebay plug wires, such as OBX, don't fit and the crimping sucks, I set I purchased had NO connection properly crimped and I had SOOOOO many problems before I found out the cause.

 

also ACCEL make some good plug wires for honda. check auto zone. ACCELL and MSD. NGK for OEM ignition