yamaha6611

hey guys, im trying to get my dohc zc put back together here before winter...

i want the machine shop to block post it before they bore it, if i just print the instructions off this site and say go for it, will they be able to do it right

they dont do much honda stuff so this is new to them, and also me i have never done it.


what do you think, it seems pretty straight foreward...

thanks,

matt

-SKUM-

Skip the block posting, and just get a good tune.

Smith-02

block posting is a ------ way of making it better. sleeve it or tune it right, i highly doubt youre going to make 400whp like a bunch of d-series guys do on here with stock blocks.

yamaha6611

really?? i thought it was a good move

my build...

wieco piston
nippon rings
TTrods
acl race bearings
cams
p06 comp. with moates 2 timer
20g
(theres too much more to list i dont feel like it)
im shooting for 350whp on pump gas, 10:1 compression


awsome response guys thanks


matt

-SKUM-

no need to block post

yamaha6611

oh damn then i should be good, i figured my zc sleeves wouldnt take..

theyre .20 over... still no worries? im shooting for around 20psi on that 20g, whatever makes me that 300 mark i dont care...

danz

post it if you want to. its just not 100% necessary.

NIGn0g

If you had OC to your ZC you should be good to 400hp!

seerex

No block posting, stock sleeves and a good tune; https://www.homemadeturbo.com/forum/...?topic=97232.0


BTW Xenocron FTW!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

NIGn0g

I waited till the end for a "OK?" mark but didnt happend. I'm a bit disapointed.