Do you think this will work?
04-03-2003, 12:20 PM
#1
3.0 BAR
Thread Starter
Join Date: Dec 2002
Posts: 3,703
Do you think this will work?
This is what I'm planing on using to tap for the oil feed line.
http://www.imagestation.com/picture/...3/fc66315b.jpg
first fitting on the left is the metric to inches fitting from the Autozone Sunpro Kit, then an npt extension, not even an inch long, and the T from the Sunpro kit. Then the top outlet on the t I'll use an npt to -4an fitting for the line and on the far side the oil pressure switch.
Thanks
http://www.imagestation.com/picture/...3/fc66315b.jpg
first fitting on the left is the metric to inches fitting from the Autozone Sunpro Kit, then an npt extension, not even an inch long, and the T from the Sunpro kit. Then the top outlet on the t I'll use an npt to -4an fitting for the line and on the far side the oil pressure switch.
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Street Sniper
Forced Induction
4
07-17-2006 09:43 PM
BLUEHATCH
General Discussion
7
09-14-2005 01:02 AM
miss-piggy
General Discussion
22
01-04-2004 11:00 PM
