DIY Manual Boost Controller Parts
 

For those of you building the manual boost controllers where can I look besides a hardware store for the Male/Female 1/4" x 3/16" Hose Barbs. I checked all the local hardware stores and the smallest they had was 1/4" x 1/4". Any input...?

Also where can I find the ball bearing...and the spring is that just from a clicky pen?

Re:DIY Manual Boost Controller Parts
 

If you have a Home Depot, lookin the Air Tool Section they should have what you need.

The 1/4 Ball bearing you can find at a bicycle shop.

And the spring you will need to find one stronger, they have strong springs here at a local hardware store, so I can't really tell you where the get them where you are.


Tim

Re:DIY Manual Boost Controller Parts
 

Well I found a source for the ball bearings thanks, as far as the sizes I need for the Male/Female NPT 1/4" x 3/16" Home Depot DIDNT have them in the air tool section. I asked if I could order too and they said no...

Re:DIY Manual Boost Controller Parts
 

I will have to look for you and see what I come up with on those for you.

Tim