DIY internal wastegate psi tester!!! (cost less than $5)
 

so i've been doing research for the last 2 weeks trying to figure out what psi my internal wastegate fully opens. the results ranged from 7psi to 25psi.. and i just couldnt trust that kind of range.. so i decided to rig up a ghetto diy psi tester. works well for anyone who's unsure aobut the psi setting of their internal wastegate, or anyone who's trying to adjust it and wants to check real fast.

and since a few people have been asking about what psi the td05h big 16g actuator opens... its 9psi.

items used
1. wastegate actuator (duhh)
2. vacuum hose.
3. portable tire pressure checker meter thing ($1.00 at autozone)
4. electrical tape
5. vice. (or you can use your feet to pull back the actuator)

electrical tape 1 end of vacuum hose to the tire pressure checker. make sure no air can escape out of it or else the readings will be off.
http://i127.photobucket.com/albums/p...f/IMG_1572.jpg

next, mount actuator mounting point to the vice.
http://i127.photobucket.com/albums/p...f/IMG_1576.jpg

pull the actuator back as if it was fully open
http://i127.photobucket.com/albums/p...f/IMG_1582.jpg

WHILE STILL PULLING THE ACTUATOR BACK ALL THE WAY: put other end of the vacuum line into the fitting on actuator
http://i127.photobucket.com/albums/p...f/IMG_1583.jpg

then release actuator and see the results! (try several times just to make sure)
http://i127.photobucket.com/albums/p...f/IMG_1579.jpg


hope this helps anybody out who is going crazy about trying to find out what psi their wastegate actuator is set at!

Re: DIY internal wastegate psi tester!!! (cost less than $5)
 

nice work man that helps things out alot

Re: DIY internal wastegate psi tester!!! (cost less than $5)
 

if that is accurate that is pretty bad ass and really use full. im going to have to try that some time

Re: DIY internal wastegate psi tester!!! (cost less than $5)
 

i vote sticky

Re: DIY internal wastegate psi tester!!! (cost less than $5)
 

Why not just leave the actuator on the turbo and watch when the flapper opens?

Re: DIY internal wastegate psi tester!!! (cost less than $5)
 

i'm still waiting on my oil and coolant lines to come in the mail, so i figured i might as well do this.
the diy pressure reader said 9psi exact... and i got a few pms and emails from other people who have the same turbo and they said 9psi. (reason why evo's boost higher is because they have a boost controller and thats why other sites said 20-25psi.

Re: DIY internal wastegate psi tester!!! (cost less than $5)
 

No I mean leave the actuator on the turbo while the turbo is off the car so you can watch the flapper open. Did you think I was proposing you watch the flapper while the turbo was installed? Unless you have x-ray vision or no downpipe; that would be impossible.

Re: DIY internal wastegate psi tester!!! (cost less than $5)
 

i did a similar thing, except i pressurized the actuator and seen when it opend fully.

Re: DIY internal wastegate psi tester!!! (cost less than $5)
 

Yeah when I read your first post I was like "WTF is he talking about." LOL


Oh and I vote sticky also

Re: DIY internal wastegate psi tester!!! (cost less than $5)
 

Nice work, pretty sure it mill work for external wasgates, too.
Just push in the valve with something?